Here are a few quick pictures of a brand new Traeger grill. You can see that there are just a few parts to assemble and then it's time to fire it up and cook!.
Unload your new Traeger Grill.
Unpack the Traeger from the box.
First, put the handle on using 2 nuts and washers.
Next, attached the Chimney using 2 nuts 2 washers.
Third install hopper with 4 bolts 4 washers
Place deflector sheild over the fire pot.
Place drip tray above deflector sheild.
Install grill grates.
Plug it in and now your Grill'n!
Adding a digital controller
Remove 3 speed switch replace with digital, mount RTD heat sensor probe inside cooking area most cases left hand side of unit, connect rtd probe wires to top left rear of digital control.
Digital Thermostat Wiring Color Codes:
RED - Auger Motor
ORANGE - Combustion Fan / Muffin Fan
PURPLE - Hot Rod
BLACK - Power Cord
NOTE: Wires can be interchanged without causing an electrical short.
Add the heat temperature probe (RTD probe)
Always start your unit on 180/225 never smoke or high, when the temperature of the Traeger reaches 100 or higher turn to desired temperature.
